Hose Live Length
The live length of the hose assembly must be sufficient in order for the hose to properly meet the movement requirements. A hose assembly with a live length shorter than suggested could cause premature failure.
Lateral Offset Motion
This motion occurs when the hose centerline is moved in a plane perpendicular to the longitudinal axis with the end remaining parallel. Dynamic offset motion should never be more than 25% of the minimum centerline bend radius. See Lateral Offset Motion.
Angular Offset Motion
Angular movement is defined as the bending of the hose so that the ends are no longer parallel. Amount of movement is measured in degrees from centerline of the hose if were installed straight. See Angular Offset Motion for design information on angular offset.
Axial movement is compression or elongation along the longitudinal axis. Metal hose assemblies installed in line with the longitudinal axis of the piping should not be subjected to axial movement.
Two design options are available to compensate for axial movement. The first option is installation of the metal hose assembly perpendicular to the longitudinal axis of the pipeline. As axial movement occurs, the metal hose assembly will be subjected to lateral offset. See Lateral Offset Motion for additional design information.
The second option is the use of a Class “B” traveling loop. See Radial Movement for design requirements of traveling loops.
Torsion movement occurs when the hose is twisted or torqued such as when the hose bends out of plane or during improper installation.
Twisting forces are extremely destructive and are one of the most common causes for premature failure.
The rate of flexure that the hose is subjected to in a given time period. Three basic types of motion
frequency include vibration, dynamic motion and continuous motion.
This is low amplitude motion occurring at high frequency. Vibration is normally found in engine exhaust, pump and compressor applications. Hose resonance must be avoided to prevent premature failure. Consult OmegaFlex engineering if hose resonance is anticipated or for additional vibration data.
Non-continuous or intermittent motion such as the result of thermal expansion. Dynamic bend radius is used in calculations determining the hose live length for lateral offset, angular offset and radial motion during dynamic or intermittent flexing.
A non-moving or fixed radius bend in a hose assembly used to compensate for misalignment.
Regular cyclic motion at a slow cyclic rate and constant travel. The dynamic minimum centerline bend radius must be doubled on continuous motion applications.
The uncontrolled motion of a metal hose such as motion that occurs during manual handling.
The minimum radius the hose can be bent and still maintain the integrity of the hose. Usually expressed as dynamic or static centerline bend radius. The bend radius is used in calculations associated with angular and lateral offset motion.
The number of cycles a hose is flexed before failure. Some factors that affect cycle life include working pressure, temperature, bend radius, hose and braid materials. OmegaFlex uses the ISO10380 fatigue test standard for cycle life testing. See ISO 10380 Summary for a more complete description of the ISO 10380 standard.Download PDF